DPM

DPM
Threads Started: 0
Posts: 12
Strapline: Registered User
Location:
Occupation:

Posts

Re: Kiln feed flow meter

If everything said above didn’t help you, (which should be in most cases), try to check the motorized valve that cont...

Re: Kiln RPM

Check first how you get the indication of kiln speed from field sensor going to your PLC or CCR monitoring system. I...

Re: How to calculate the no. of Bricks per ring

This might help. I've used this back when I was still working. The formula is there, but you just need to compare it...

Re: Allignment and skewing of middle kiln Roller

Philips Kiln Services provide worldwide expertise on your case - my recommendation. check their site. http://www....

Re: Shimming

As far as I know, there's no formula for this. You have to use some special/external instruments to do this. Doing i...

Re: High fuel consumption

Asim, Assuming everything is normal in your fuel, you might try to check your feed to speed ratio and verify source...

Re: Kiln Shell is Wet

The black liquid is the reaction of these deposits (in the form of iron oxides) from water in the air. These black ...

Re: VRM HEAT MASS BALANCES SHEET

elwathig, I just digged some old files from my disk, it's probably what you need. I hope it helps. Check your em...

Re: flushing of kiln feed through preheater

Yes, it always happens during commissioning! Even an instant power outage can trigger a quick flush, especially for ...

Re: Problem with cooling fan of IKN grate cooler

vuha, Though i'm not directly connected with IKN, these type of cooler (or any new generation clinker coolers) can...