Engr

Posts

Running Raw Mill without kiln gases.

Dear Xperts Why raw mill is recomended to be stopped with kiln stoppage. If mill is kept run at low feed withou...

What should be the direction of separator rotor?

Dear experts. Mill separator rotor should move in same direction as flow of guide vanes or opposite? More over,...

re FLOW CALCULATION AT BLOWER INLET

Dear bro, u not need to take any consideration for the filter as it has no any connection with vol flow calcuatio...

re operation interlocks required

Dear arman, can u tell us that when your feed trip then what happened to the ID fan speed and how much pressure ch...

Re: kiln inlet material flushing

Dear Prisoner, What we have observed two main reasons for material leakage from inlet seal. Either your inlet troug...

Re: Formation of coating in the kiln

Dear Mr Vuha, I think you should try to stabilize your Sec and Ter air T as much as possible. Also coal conveying a...

Re: Rush in Kiln & heavy coating in KIln inlet

Dear Wahid, As you are mentioning heavy coating at inet. This seems to be the main cause of kiln rush. You can take...

Re: Run plant without cyclone dip tubes.

Thanx all

Light up the kiln without baghouse fan/EP

Dear All, I want to discuss that we are having a problem at our plant regarding main bag house fan. We want to fire...

Re: high ph outlet temp.

Dear Raj, One reason for this high T is the PH top feed divertor, that has some material leackage. This will cause ...