Santosh_01
8 posts
TimePosted 01/04/2014 17:33:10

Kiln supporting roller deflection

Dear Sir

What are the possible reasons for high deflection of supporting roller.

Reply


Know the answer to this question? Join the community and register for a free guest account to post a reply.

niladri
4 posts
TimePosted 07/05/2014 18:21:44
niladri says

re Kiln supporting roller deflection

see page 15 of the attachment.

 

mainly due to crank in the kiln shell (may be due to mechanical and thermal) the roller shaft got deflected,

the range is 0 to 0.15 in green zone and above 0.2 it is in red zone.

Reply

Santosh_01
8 posts
TimePosted 15/05/2014 13:30:36

re Kiln supporting roller deflection

Thanks Dear Niladri

In our kiln deflection of P2 varies from 0.06 to 0 .19 mm without any much change in shell temperature and kiln main drive load. Is it possible to bring down it within normal range by hot alignment of kiln?

Reply

niladri
4 posts
TimePosted 20/07/2015 14:53:40
niladri says

re Kiln supporting roller deflection

check the ovality of the kiln shell under this tyre means just within 1 mtr of the tyre.and let me know the value  .I am attaching a relation of ovality tolerence of kiln diameter and ovality. check the migration of this tyre. .

Attached files

Reply