Kumar
84 posts
TimePosted 13/10/2015 10:21:55
Kumar says

Kiln creep

Dear Sir,

We are noticing higher kiln creep at our middle tyre(>60mm) and at the 3rd tyre inlet side (>30mm). What can be bad effects on the klin and on the refractory?

 

Regards

Reply


Know the answer to this question? Join the community and register for a free guest account to post a reply.

Arvind Kumar
1 posts
TimePosted 18/10/2015 17:39:11

re Kiln creep

30 mm creep at inlet Tyre is more but need not to worry you can do the shimming in your next oppertunity. 

But 60 MM creep at middle Tyre (Burnning Zone) is very much high. This high creep is very dangerous for tyre. The Tire will wear fast. this will further lead to Refractory damage.  

If you are always getting this creep at middle tyre then need to do the correct shimming urgently.

If this new problem is from some time then there may be nose ring formation (Heavy Coating) inside the Kiln. 

Reply

Kumar
84 posts
TimePosted 28/10/2015 10:47:44
Kumar says

re Kiln creep

Thanks Mr Arvind.

Reply