Wahid Ullah
Posts: 16
Strapline: Registered User
Location:
Occupation:
Posts
Re: id fan motor bearing temp problem
dear check ur shaft alignment & lubricant life. i think ur lubricant life has expired & its viscosity become low. s...
Re: id fan motor bearing temp problem
dear check shaft alighnment & lubricant life. i think the life of ur lubricant has expired & its viscosity become lo...
Re: vibration in VRM
Please let me know that what was grinding pressure on 90mm dam ring.
Re: refractory in emergency condition
upto 120mm cut the bricks. if gape come upto 10 r 20 mm then before ring full brick cut upto 110mm & next also come u...
Cement mill low feed
we have a problem in cement mill operation. Our mill feed not increase from 130t/hr while our capacity is 170t/hr. Mi...
Re: VRM HEAT MASS BALANCES SHEET
please also send me engrwaheed06@yahoo.com