AN - Kuwait
Posts: 29
Strapline: Registered User
Location:
Occupation:
Posts
Re: Mill Draught
Roughly the outlet draught is 30 times ID in mm .And you can calculate by taking the empty volume of mill,residence t...
Re: Hurrivanes
Dear Raj, I do not have the old ICR.How can I get it.
Re: kiln RPM increasing
Gear box ratio is required and the other parmeters like Volumetric load,power max.capacity.And also if you change the...
Re: Use artificial gypsum for cement
Characteristics will be same only cost calculations you have to do.If it is commerecially OK that you can save some m...
Re: JPF Fan impiller coating
Hi, There are two solutions 1) .You can introduce fine sand from the downcomer duct at regular intervals.2) Install...
Hurrivanes
Dear Clark , What is the Hurriclone/Hurrivane technology? We have 5th stage PH system LP Cyclones.Can we try Hurr...
Re: How much velocity to be maintaine across the ball mill
1.5m/sec.for closed circuit and 1 m/s for open circuit.
Re: JPF Fan impiller coating
Take the sample of the coating and check it for Fe may be the raw mix composition is changed from previous to now.
Re: % of grinding media in ball mills for both chambers
You can get FLS COMMUNITION MANUAL which will give you the tables regarding the calculations.And also how to estimat...
Re: Length of flame
The length of the flame in general will be 2.5 - 3 times of kiln Diameter.