Kumar
84 posts
TimePosted 08/02/2012 12:04:45
Kumar says

Material Spillage from Kiln Inlet

Dear Experts,

                  What can be the reasons of material spillage from kiln inlet seal? Our kiln many times even running under capacity start spilling material from the seal. The system has bypass circuit which is running always but still we fce this problem. Kiln is 5 Stage, ILC, single string. And below Cyclone 4 is material splitter for splitting the material towards the upper and lower part of the calciner. Kindly share your openion in this regard also that what should be the splitter ratio? 

Reply


Know the answer to this question? Join the community and register for a free guest account to post a reply.

Wahid Ullah
16 posts
TimePosted 12/02/2012 13:04:53

re Material Spillage from Kiln Inlet

any ring in kiln or heavy coating. f yes then degree of filling become high and spillage start at kiln inlet

 

Reply

ILA
49 posts
TimePosted 18/02/2012 20:03:47
ILA says

re Material Spillage from Kiln Inlet

Dear

I`think you may need to have a look on your kiln inlet troght segments ,

Thanks

 

ILA

Reply

Kumar
84 posts
TimePosted 22/02/2012 11:39:26
Kumar says

re Material Spillage from Kiln Inlet

Thanks Mr ILA,

                     We found inlet throat casted area size differed from the designed height because at the time of casting, the person used anchors which were small in length compared to the length in design. Now we are changing it.

Reply