Home » Forum » Technical Cement Forum

Write A New Post Technical Cement Forum


whatsapp group cement

Started by sreza55
19/12/2017 11:37:55
Time Latest reply:
06/12/2019 19:17:18
by elwathig
Comment 34

Kiln not thrusting

Started by Kayode
11/11/2019 17:52:02
Time Latest reply:
11/11/2019 17:52:02
by Kayode
Comment 0

How to handle hot spot at kiln burning zone

Started by Sangia
27/10/2019 15:18:46
Time Latest reply:
27/10/2019 15:18:46
by Sangia
Comment 0

Mr M.N Philemon

Started by MNphilemon
15/10/2019 12:22:21
Time Latest reply:
15/10/2019 12:22:21
by MNphilemon
Comment 0

cement color

Started by Nasir
11/08/2019 15:10:17
Time Latest reply:
10/10/2019 15:00:48
by mark.antonio
Comment 1

Trainer / Visiting Faculty Pyro process Optimization

Started by Bhaskar Agate
05/10/2019 13:22:33
Time Latest reply:
07/10/2019 15:18:38
by technical cement forms
Comment 1

Heat balance excel sheet - detailed calculations

Started by Er.Hussaini
25/10/2009 06:02:46
Time Latest reply:
05/10/2019 10:44:10
by Ramesh Aital
Comment 26

High CO up to 2% at kiln inlet

Started by Ramesh Aital
10/09/2019 08:05:07
Time Latest reply:
02/10/2019 16:22:08
by gks
Comment 2

.

Started by BCast
22/09/2019 04:09:12
Time Latest reply:
22/09/2019 04:09:12
by BCast
Comment 0

bricks calculation

Started by surya kiran
11/02/2014 12:58:08
Time Latest reply:
20/09/2019 06:34:40
by N k
Comment 14

Kiln maintenance: unnecessary expense or profit generator?

Started by mark.antonio
19/09/2019 10:08:34
Time Latest reply:
19/09/2019 09:09:23
by mark.antonio
Comment 1

What could be the good calcination at cyclone 4 discharge in 5 stage preheater with separate line calciner

Started by Ramesh Aital
10/09/2019 08:16:19
Time Latest reply:
10/09/2019 08:16:19
by Ramesh Aital
Comment 0

using alternate fuel

Started by technical cement forms
05/07/2019 13:00:47
Time Latest reply:
11/08/2019 15:26:03
by technical cement forms
Comment 2

Clinker grindability

Started by shastrib
13/03/2013 18:29:12
Time Latest reply:
15/07/2019 09:41:01
by Wahidur Rahman
Comment 9

hot gases required to start a new roller press finished raw material grinding

Started by xxxx
09/07/2019 18:12:04
Time Latest reply:
09/07/2019 18:12:04
by xxxx
Comment 0

Cooler ESP high dust emission

Started by Tam Nguyen
13/12/2013 02:27:44
Time Latest reply:
05/07/2019 03:20:27
by charliehill
Comment 8