1 posts
TimePosted
09/06/2016 18:57:41
Burner
says
What are the purpose of kiln movement uphill/downhill?
Dear CEMNET members
What are the purpose of kiln movement uphill/downhill?, what will happen if the kiln operates without movement?.
Thank you.
Know the answer to this question? Join the community and register for a free guest account to post a reply.
1 posts
TimePosted
07/04/2019 21:49:18
FJ
says
re What are the purpose of kiln movement uphill/downhill?
The purpose of kiln movement is to get equal wear in tires and rollers. Rollers should be adjusted to “float” the kiln between the upper and lower thrust rollers. The gap between Thrust rollers and tire is 1/4". The total amount is 1/2".
When rollers are misaligned or conical-shaped, the kiln load is spread over too small an area. This causes high surface stresses resulting in pitting.
Best regards
Page
1
of
1
1