2 posts
TimePosted
02/06/2021 10:26:17
Hanhccid
says
Calculate kiln ID fan after installing a PH boiler
my PH fan (Kiln ID fan) is desigened as follow:
|
Parameter of Kiln ID fan |
Design |
Actual operation |
1 |
Fan inlet pressure (mbar) |
96,5 |
everage: 90 |
2 |
Inlet air flow (m3/h) |
552.000 |
530.891 m3/h |
3 |
temp (oC) |
320 |
335 |
4 |
Power Consumption (kW) |
2.100 |
everage: 1.900 |
5 |
Fan speed (rpm) |
990 |
100% (full) |
We plan to install a waste heat recovery system (WHR boiler) into the system (with resistance increase about 10 mbar), the ID fan inlet temperature is only 195 degrees (after PH boiler)
the question is, after installing the PH boiler, does the ID fan meet the requirements, is it necessary to replace the fan.
Know the answer to this question? Join the community and register for a free guest account to post a reply.
Page
1
of
1
1