ILA
Posts: 49
Strapline: Registered User
Location:
Occupation:
Posts
Re: compressed air required for F K Pump
Dear Mr. Raj A FK screw pump is nothing else than a feeder. the desired conveying pressure determines the used pip...
Re: Doubts in Cement Industry
Dear Shaik When you operate in extremely short flame and very concentrate heat transfer , the process material wi...
Re: Low early strength of clinker
Dear Mr. Diaz For kilns with grate coolers, the burner tip should be in the plane of the kiln nose or slightly i...
Re: Tyre Migration
Greetings The normal maximum design ovality for a tyre is .2% relative to the inside diameter of the kiln shell. ...
Re: Conversion C2S to C3S
Dear Mr Azher The tendency toward coating formation or the coatability of the clinker increases with the amount of...
Re: How to increase C3S in clinker
Dear Tam With your case there are more than LS And SR :- 1- Raw meal particle size and mixture ( homogenize ) 2- ...
Re: Conversion C2S to C3S
Dear Gks Without the presence of liquid, the conversion of C2S and free lime to C3S at normal clinkering temper...
Re: Grate cooler Plates bolts are Damaging
Dear Mr. Feroze Kindly , To improve the plant performance ( Upgrading ) , ,. Process optimisation must be ...
Re: khd pyro jet burner
Dear Shahzad Kiln rings are sections of heavy coating, usually in the burning zone, though sometimes also near th...
Re: khd pyro jet burner
Dear Mr. Shahzad coal firing involves a single pipe burner through which the mill carrying air together with entr...