Engr

Engr
Threads Started: 4
Posts: 19
Strapline: Registered User
Location:
Occupation:

Posts

Re: id fan motor bearing temp problem

Dear ArmanKhan, Heating phenonomenon occoured in bearing is known as 'Seizing' Most common reasons of bearing ...

Run plant without cyclone dip tubes.

Dear all, Can we operate plant on full capacity without having DIP tube in bottom cyclone. What are expected effec...

Re: kiln shutdown program

Dear Elwathig, Decision taken by operator looks ok b/c in most of plants, PH fan stoppage is interlock with kiln fe...

Re: kiln heating up

Dear Elwathig, It is not necessary to start PH fan for kiln heat up. I worked on one plant where we use to start PH...

Re: what is the Max. Nitrogen gas pressure in accumulator for vertical roller mill - hydraulic cylinder

Dear Arman, N2 depends mainly on your operating grinding P. Most probabily 2 problems will happen with very low or...

Re: Suitable temperature for cement storage in silo and also for better roto packer performance

Dear Menaria, As you have mentioned jamming problem in roto packer, you have to keep in mind that at nozzle filling...

Re: combustion air

Dear Armankhan You need following analysis for coal. C, H2, S, O2 C+ O2 ....>  CO2 2H2 + O2....> 2H2O S+ O2.....

Re: kiln shutdown program

Dear Elwathig, For a small  stoppage, what I suggest to run PH fan with min speed with damper close b/c when ever f...

Re: what is the Max. Nitrogen gas pressure in accumulator for vertical roller mill - hydraulic cylinder

Dear dhanu. Max N2 press in accumulators is derived according to manufacturer's allowance. Accrding to  Gebr. Pfei...