admin
1156 posts
TimePosted 22/08/2006 10:21:35
admin says

Raw milling Question 1

Our facility operates two Humboldt air-swept ball mills for raw meal production. Combined capacity is 100tph. We would like to optimise the raw meal circuit, in particular, mill loading. Unfortunately, there appears to be very little information on the optimisation of air-swept mills. How can mill throughput be improved, utilising existing equipment? The separator is a mechanical classifier, with adjustable vanes. Current reside set point is 15 per cent on 90 micron. We currently use sonic ears to determine mill loading, with mill and fan current also available. There is also a proposal to implement a grit return weigh system to determine the recirculating load. Would this be worthwhile addition, with any positive process benefits? In summary, we wish to determine the most cost effective means of attaining optimal material levels in the milling circuit, with the intention of automating the operation sometime in the future.

Reply


Know the answer to this question? Join the community and register for a free guest account to post a reply.

admin
1156 posts
TimePosted 22/08/2006 10:21:35
admin says

Re: Raw milling

If you are adequately controlling the kiln feed residues to 15 per cent I am not sure what the grit return weigher is going to tell you. Will you be able to remotely adjust the vanes of the mechanical separator from the control room while the mill is running? If not I would suggest periodic sampling and measuring residues around the circuit is all you need to do to determine the rejects rate. What do you mean by "optimise" the raw mills? Do you need more raw mix output? Is there sufficient drying capacity in the mills? I presume they are swept by preheater exhaust gases?

Reply

admin
1156 posts
TimePosted 22/08/2006 10:21:35
admin says

Raw milling Question 2

How does the content of chromium have influence in quality and performance of grinding balls? Is it better a low content of this metal to improve hardness in balls?

Reply

admin
1156 posts
TimePosted 22/08/2006 10:21:35
admin says

Re: Raw milling

If the grinding balls contain chromium then they are forged, hard grinding balls. If the balls don't contain chrome then they are softer mild steel and the wear rate will be higher. Balls containing chrome cost more but last significantly longer and maintenance of the optimum media loading in the mill is easier. Many cement companies use soft media for raw grinding as the wear on the steel simply increases the iron content of the raw mix slightly. Most cement companies use hard media for cement grinding as the wear rate on soft media when grinding clinker is too high and the mills need continuous recharging.

Reply