72 posts
TimePosted 27/10/2008 20:04:14
Nael says

Raw mill outlet duct wear rate


I would like to know some information about the wear out in duct, which I have raw mill balling mill swept air type and we face problem with wear out at outlet duct,so I need some information to reduce that wear and how can I calculate the wear rate?

best regard


Know the answer to this question? Join the community and register for a free guest account to post a reply.

Michael Clark
312 posts
TimePosted 28/10/2008 10:47:20

Re: Raw mill outlet duct wear rate

This is a common problem. There are wear resistant linings available that can be applied to the inside of ducts. The wear rate can only be measured by weighing sections of duct when installed and then when replaced. Alternatively coupons of the same material as the duct could welded onto the inside of the duct.