Ramesh Aital

Ramesh Aital
Threads Started: 18
Posts: 24
Strapline: Registered User
Location:
Occupation:

Posts

Air Flux

Dear Friends, What is meant by Air Flux in CIS MFR system grate cooler, and what is min air flux to be maintain...

Narrow coating inside cement ball mill

Dear Sir, We have observed narrow coating inside cement mill comp 1 near diaphragm, the coating is almost covered ...

re Reasons for drop in Kiln inlet temperature

Dear Sir, We have checked inlet oxygen and Co%, oxygen is around 3.0% and Co is 0.03%, the calcination zone are...

Reasons for drop in Kiln inlet temperature

Please any body suggest what would be the possible reason for drop in kiln inlet temp, we have rotary kiln of 3.0 ...

Corelation between burner and clinker quality/strength or raw mix design

Can anybody suggest is there any corelation between burner flame with respect to clinker quality and strength, ple...

Fall in raw mill tph after addition of clay

Dear Sir, We have airswept ball mill Dia 2.8 x 7.32m length for raw material grinding, before it was giving 48 ...

High Exit vent temp at cement mill outlet

We have open circuit ball mill grinding OPC 43 grade, feed moisture 2% max, Inlet temp 35 Deg C and outlet temp we...

Benfits of reducing iron% in Kiln high alumina refractories

Dear Sir, How far it benfits if we reduce iron % say from 3% to 2% in kiln burning zone 60 to 70% alumina brick...

re Kiln inlet draft going on higher side, and drop in production by 10%

High, We have 5 stage preheater system, we have not installed calciner and we have secondary firing above smoke...

Kiln inlet draft going on higher side, and drop in production by 10%

Dear Sir, We have 500 tpd kiln (3m x 42.5m length) with 5 stage suspension preheater system, we are getting onl...