Michael Clark
Posts: 324
Strapline: Registered User
Location:
Occupation:
Posts
Re: Volatility & Volatilization
Hi Nael, The volatility is the tendency to volatilise in the process. Volatilisation is the process of volatilisi...
Re: kiln mainhole location
At the position of minimum bending stress. This is found at some position fairly close to, but a bit out from, each ...
Re: Raw mill outlet duct wear rate
This is a common problem. There are wear resistant linings available that can be applied to the inside of ducts. The...
Re: Kiln cooling
The heating and cooling rate of the kiln need to be adjusted and controlled dependent on the refractiory work that h...
Re: Oxygen Enrichment Technique
Oxygen enruchment has been used on more than 20 cement kilns in the USA. However, there is expense involved and ther...
Re: Kiln Ring
There could be many reasons Naison. They will be connected with the feed or fuel composition or the physical and che...
Re: Petcoke!
The "pet" in petcoke means petroleum. If is petcoke then its a biproduct of oil refining. Coke from coal is a totall...
Re: Preheater fan coating farmation
The reason for fan impellor coating are connected with the process, i.e. the temperatures, amount of dust leaving th...
Re: POINT LOCATION OF EXPANSION JOINT IN DUCT
Fundamentally, this is an OEM issue and different equipment suppliers can and do have very different approaches ...
Re: separation factor
Electron, There is no “separation” factor – it is a homogenisation or blending factor. It is the variation of the...