bazarah

bazarah
Threads Started: 4
Posts: 17
Strapline: Registered User
Location:
Occupation:

Posts

VRM vs Ball Mill for Cement Grinding

Good Days! Gentlemen, Anybody in this forum who have had some practical/extensive experience on Vertical R...

re calculation of flame momentum of a multi channel burner

Good Days! Dear Mr. Charli, kindly send me the excel sheet of momentum calculation at my ID: abazarah@ho...

Re: how to estimate the wear rate for Ball mill

Dear Sir Vikpro, Kindly if possible can u send it to me also at abazarah@hotmail.com Regards, A.Bazarah

Re: VRM HEAT MASS BALANCES SHEET

Dear : Mr. SHAFI AHMED please send me the excel sheet in my e.mail  abazarah@hotmail.com Best Regards

Re: BY PASS RAW MATERIALS

Dear ’ s friends   We are   planning to used By Pass material as additive in OPC mill What is the ...

Re: BY PASS RAW MATERIALS

Normal 0 false false false MicrosoftInternetExplorer4 ...

Re: high free lime

Dear sir Jojo I am very much thank full to you for response the type of fuel is crude oil if you have pr...

Re: Heat Balance

Dear Mr. Bhandari, we are highly appreciated to send me the calculation, my mail ID as below. Th...

Re: high free lime

Dear sir I am very much thank full to you for quick response These problems happen after kiln stoppage t...

high free lime

  Hey Friends; How do you know the kiln feed is hard to burn? If free lime high in clinker   it ...