kiln

Dear expert,

 Good morning

PL. suggest point wise,

what is relation between following

 kiln slope vs kiln speed

kiln slope vs kiln dia .

 kiln slope vs kiln length

 for selection of new kiln .

With regards GKS

Reply

Know the answer to this question? Join the community and register for a free guest account to post a reply.

Re: kiln

The main (process) design parameters are

- retention time

- volume loading

- gas velocity

 Gas velocity should be lower than 12-13m/s at kiln inlet

Other parameters already discussed in this thread: http://www.cemnet.com/cs/forums/thread/3183.aspx

best regards

Reply