elwathig
72 posts
TimePosted 22/08/2010 21:13:34
elwathig says

high free lime and liter weight

dear all good evening we are suffering from high free lime and litter weight.notice that the raw meal analyeses are : LSF=94-95 SM=2.2 AM=1.6 And our kiln is running with 60% fron full capacity due to this problem and some blocking in pc area best regard

Reply


Know the answer to this question? Join the community and register for a free guest account to post a reply.

Bhaskar Agate
84 posts
TimePosted 24/08/2010 14:18:46

Re: high free lime and liter weight

Adjustment of LSF 98-99 and SM 2.4-2.6 with AM 1.6 may please be attempted for raw meal and accordingly individual components of raw meal needs correction.i.e.redesign raw mix keeping in view the fuel being fired in the kiln.

 Regards

 Bhaskar Agate

Reply

Ted Krapkat
537 posts
TimePosted 25/08/2010 05:28:20

Re: high free lime and liter weight

elwathig:
we are suffering from high free lime and litter weight.notice that the raw meal analyeses are : LSF=94-95 SM=2.2 AM=1.6 And our kiln is running with 60% fron full capacity due to this problem and some blocking in pc area best regard

Hello Elwathig,

I have a couple of questions;- 

Are you experiencing both high free limes and high litre weights?

Your raw meal chemistry suggests a relatively easy to burn mix (depending on your fuel's ash content of course). What fuel do you use and what is its ash content? Do you use the same fuel in the precalciner?

What is the LSF, SM and AM of your clinker?

What is the nature of the blockages in the precalciner area? ie hard/soft/large slabs etc. and where (and how often) do they predominately form?  I know it is always very difficult to obtain a sample, but have you ever tested the blockage material to see if it is sulphur or alkali related?

Regards,

Ted.

Reply

BLM
36 posts
TimePosted 26/08/2010 14:52:44
BLM says

Re: high free lime and liter weight

Dear elwathig,

If iam not wrong your on line oxygen analysers are not working. Blindly uou are pumping the fuel into kiln as well as PC. If you are getting high free lime and high literweights that may be because of reduction atmosphere in the kiln. this leads to partial blockages in the pre-heater, which your are getting now. You can try by reducing fuel fired to kiln to maintain the minimum oxygen level at kiln inlet. If you have damper in TA duct you can reduce to increase the oxygen content in the kiln though. It is better to carryout the kiln air balancing to know the gas distribution in between secondary air and tertiory air.

Regards,

BLM

Reply