BK

Posts

Coating formation in Preheater riser ducts

Dear all, what are the chemical and physical parameters for formation of the Porus Coating in Kiln inlet riser duct...

Kiln Firing with Natural Gas

Dear all, Can any body tell me the details regarding Kiln firing with Natural gas and Properties. with best regard...

Re: Alk / SO3 ratio

Hai Electron, The concentration of sulphur may increase to a point where it affects kiln operation causing build up...

Re: AF

Hai Stephenb, The temperature by which the melt forms depends on the AF. The lowest temperature is obtained when th...

Re: Heat Balance

to all my dear friends,   Please login the following Net ID to get completer calculations regarding Kiln Heat Bala...

Re: Heat Balance

Hai my dear friends, I have complete calculation regarding Kiln,Ball Mills, VRM, Crushers etc,...  Mass and Heat ba...

Re: how to estimate the wear rate for Ball mill

can u send same for mail ID : bandarikomar@yahoo.co.in

Mill Draught

How much Draft( i.e,.in mmWC ) should be maintaine at Mill inlet and Outlet to get optimum production for 5m x 15m ba...

how to estimate the wear rate for Ball mill

How to estimate the Grinding media wear rate for cement grinding ball mill and how much makeup load we have add to g...

How much velocity to be maintaine across the ball mill

Hai friends Any body help me to estimate the Velocity across the Ball Mill for Cement Fine grinding in 1st chamber ...