fac09
Posts: 16
Strapline: Registered User
Location:
Occupation:
Posts
Re: Raw mill drying problem
We are considering switching our system (we dry our raw mill feed with gas fired furnaces) to partially drying the f...
Increased stack air flow - fuel efficiency?
Over the years our stack flow rate has run at about 80k wet scfm, during this year the flow gradually increased unti...
Re: 2nd stage showing dead cold on infrared image
Thanks Dr. Clark Indeed, the only physical problem we found was hard buildup, I suspected the buildup but I was ...
Re: 2nd stage showing dead cold on infrared image
Thank you for your reply. Blue temperature was about 60C when all the other stages are around 130C. Almost 2/3 of th...
2nd stage showing dead cold on infrared image
The bottom section of our 2nd stage is blue (cold) all the way on an infrared thermal image. This is a 4 stages preh...
Water Spray in front of Finish Mill
We have moved our finish mill water spray from the second compartment to the front of the mill. Since then th...