Michael Clark

Michael Clark
Threads Started: 0
Posts: 312
Strapline: Registered User
Location:
Occupation:

Posts

Re: Kiln heat up time

The rate of heating (and cooling) of the refarctory lining of the burning zone should not exceed 50 degrees C per hou...

Re: Is this Decision Right........?

It doesn't sound as if the maintenance was very well planned or coordinated.

Re: Dust emission through main Stack

There are well documented cases where particles of ammonium salts have condensed from the exhaust gases in a plume af...

Re: Cement Silo Extraction Problem

What you need to monitor is the degree of dehydration of the gypsum during cement mill operation.

Re: projection at 8000 tpd

You need to enrol on and study the CemNet Training Pyroprocessing course.

Re: Cement Transport by F.K.Pump

You need to ask IBAU.

Re: new power consumption figures

You need to enfol on and study the CemNet Pyroprocessing course.

Re: STRENGTH POTENTIAL

Both give the same hydrated calcium aluminate products. C3A reacts more quickly than C4AF so would be expected to mak...

Re: Gelation in Oil well cement

You need to define what you mean by gelation. If you mean thickening or setting then it is the high pressures and tem...

Re: kiln retainer rings

You would install a retainer ring to hold back the thrust of the refractory lining at the outlet or the end of any se...