gks

gks
Threads Started: 50
Posts: 147
Strapline: Girish Kumar Sharma
Location: India
Occupation: Production, QC and Environment

Posts

vertical mill

What is torque factor in VRM  in lime stone grinding  and  70% pet coke clinker grinding in VRM for opc cement grind...

kiln

Dear expert,  Good morning PL. suggest point wise, what is relation between following  kiln slope vs kiln spee...

Re: Normal coating area in kiln

hello mr M. azhar,   normally coating in side the kiln 5.0* ( effective  dia of kiln) +2.5m max.  coating thickne...

Conversion C2S to C3S

Dear expert, goodmorning Iwant know that what are factor effecting the rate of reaction for conversion...

Re: Heat Balance

Dear sir,       pl.send me soft copy of your heat balance sheet. i want verify my heat balance for six stage prehea...

Re: Fine clinker

Dear ILA,       1.     if your mill is running on high sepol return -  sepol fan flow increase with high dy.separat...

Re: VRM- VERTICAl roller mill

 Dear maddy,            I think 13.0 mm/sec. high alram only .(if vibration is percit for 20.00 sec). if vib.more t...

Re: Process measuring points location in cycone exit duct

 Dear  dogra,        1.  hello, i want to say that if you want measure temp of lifting side of material in riser du...

cooler selection

 dear expert,   I want to know .          what is difference in   IKN       with conv. Grate cooler an...

Re: Cranking sound from kiln

 Cranking sound from kiln   caused due to liquid phase change taking place in this area.  or frequent  coating  spa...