Vikpro

Posts

Re: Ash fusion temperature

 Dear Mr. Raj, Send me following details with email Id, so I can send excel sheet. Vikpro  Coa...

Re: SECONDARY AIR TEMPERATURE

Sorry I tried to insert my excel sheet by MS documet Imaging in privious post, but failed. Within 15 ~ 20 min you ...

Re: SECONDARY AIR TEMPERATURE

Re: ball mill jamming problems

Dear Paresh, I need more information about your mill, I feel  your mill ball pattern has to be redesigned. ( mail...

Re: kiln inlet material flushing

One of the reason for kiln inlet material spillage, is due to mud ring formation near kiln inlet. Possible reason f...

Re: kiln without thrust roller

Kiln floating is must for roller & tire. Yes, we can run without thrust roller only with adjusting supporting roller...

Re: Formation of coating in the kiln

Dear Vuha, Cement process parameters may fluctuate, due to small changes right from crusher to cooler. like size of...

Re: Request for feedback for a Two Chamber Cement Mill Ball Charge and Longitudinal Sieve Analysis

As per your given mill details.(mill output assumed to be 45 tons / hr) for more details you can contact me at vikp...

Re: Request for feedback for a Two Chamber Cement Mill Ball Charge and Longitudinal Sieve Analysis

As per your given mill details.(mill output assumed to be 45 tons / hr) for more details you can contact me at  v...

Re: High wear rate at mill inlet than the mill outlet shell liner plate in 1st chaber of cement mill explain????

Dear Pankaj, Why UR asking 4 same excel sheet again ? Vikpro